New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Still blinking after initial setup
Still blinking after initial setup
I installed a the recommended 1TB disk into the diskless BubbaTwo, and followed the rest of the instructions on "Installing and Re-installing". After 8-9 hours, the light is still blinking. What do I do next? (I don't want to power down in this state...) Help!
Some new behaviour
OK, I have tried a new USB drive, formatted FAT32, re-copied the files over. This seems a little more promising, but this what happens:
1. Holding power button, plug in power
2. LED flashes, continue holding button
3. LED flashing gets faster after a few seconds (longer than 1-2 secs), let go of power button
4. LED continues to flash, then flashes slower (like at the beginning), then goes solid, and Bubba shuts down (LED off, no drive noise).
Any ideas?
1. Holding power button, plug in power
2. LED flashes, continue holding button
3. LED flashing gets faster after a few seconds (longer than 1-2 secs), let go of power button
4. LED continues to flash, then flashes slower (like at the beginning), then goes solid, and Bubba shuts down (LED off, no drive noise).
Any ideas?
I just finished my new installation (unzipped the install directory to the root of my flashdrive). Release button at step 2! When i did hold my button too long it continued flashing but nothing happened (light on usb stick was not flashing and drive was not making any noise). After i did hold it untill it flased and released it, it did the trick. For 1/2Gig it was taking twenty minutes or so.